
Speech switch
When power on, the lamp enters the default settings state. That is the mode of non-specific person in speech switching state. Long pressing "MODE / Mode" button is to close or open the speech switch state. Only the “POWER / switch" key can power on or power off the lamp, speech will not work. At this point "SET / Settings" button can be used normally.
(1) Non-specific person mode
Under speech control mode, press "MODE / mode" key, after hearing the speech prompt "non-specific persons mode", anyone who repeat "Aladdin" two times(Please note that a slight interval is needed between the two sentences, about a second) the lamp will be on or off. Cut the power and then turn on the power again, the lamp will enter the default state --------- non-specific person model.
(2) Specific person mode
Under speech control mode, press "MODE / mode" key, after hearing the speech prompt “Specific person mode” you can read whatever you want. Repeat it twice under the same reading speed. And then Aladdin will be able to on or off according to what you read. Also be aware that there should be one second interval between the two sentences. Under this case, Aladdin could only listen to your mantra, others won’t work even they say the same mantra as yours. Isn’t it magical that an Aladdin lamp only listens to you?
(3) Sitting your mantra
Long press "SET / Settings" button, and there will be speech to prompt you to reset the mantra to switch on the light, and then you can record your mantra you like to switch on the light following speech prompts. Isn’t it funny?